Robot Charging Method

Attention

OriginMan uses an 11.1V 2500mAh 10C Li-Po battery as its power source, and supports charging while powered on.

The charging port of OriginMan is located next to its toggle switch. You must use the designated charger for charging; otherwise, it may cause circuit damage or charging failure.

Specific Steps

Insert the DC connector of the charger into OriginMan's charging port;
Plug the AC connector of the charger into a 220V power outlet. The LED indicator on the charger will show red, indicating charging in progress;
When charging is complete, the LED indicator on the charger will turn green. At this point, charging is finished and you can unplug the charger.